Tomsgates Beethoven Grey Oil Finish Rubberwood for Doors BTNgyDR

Specifications for door and glass installations  http://tinyurl.com/3y7awat3

Specifications for wall installations  http:y8c9x63c//tinyurl.com/

BEETHOVEN | Extra Large Dog Door | For installation in a door up to 6cm thick

✔️ Suitable for very large dogs with a maximum width of 32 cm and a shoulder height of 60 cm or more.
✔️ The passage of the flap is 32 cm wide and 45 cm high and is to be installed at about 25 cm from the floor.
✔️ With the frame included, the dog door is 42 cm wide and 55 cm high.

These pet flaps are handmade to order by craftsmen in Belgium. Made from high quality materials, these pet flaps take approximately one calendar month to be made and shipped to your home address. 

This dog door is suitable for very large dogs with a shoulder height over 60 cm such as the Bullmastiff, Rottweiler, Doberman, Bloodhound, Bernese Mountain Dogs, Cane Corso, Shepherd, Dogue De Bordeaux, Great Dane, Newfoundland. Puppies, cats, and smaller dogs can also use this pet door because they only have to open the lower slats of the flexible flap.

The unique design of these handmade wooden pet flaps makes them close silently, weatherproof and look more like vents than your average pet flap! The Bouncer can be installed into glass doors and windows, walls, and most other kinds of doors.

For an installation involving glass you would require a new replacement piece of toughened glass to be manufactured.

By law, it is a legal requirement for any glass in a door to be a safety glass and toughened safety glass cannot be cut. If you try to cut the glass, you will end up shattering the pane of glass - examples of this is when a car windscreen smashes, or you drop a drinking glass. It shatters into millions of small pieces rather than large shards of glass that can be dangerous to you and your pets.

Toughened glass has been put through several manufacturing processes that make it rigid, tough, and impervious to cutting; therefore, the hole for a pet flap needs to be cut before it goes through the toughening process as part of the manufacture of the new glass.